Wetness 4136 Medium Solids Clear Coat Kit – 4:1 Mix, 36% Solids

NOTE: Make sure product is at room temperature (72°F) before mixing.

APPLICATION

• Apply basecoat color according to manufacturer’s recommendations
• Apply 2 – 3 flowing coats of Wetness 4136 Medium Solids Clear coat (2.2 – 3.6 mils @ 1.2 mils per coat)
• Flash for 10 – 15 minutes depending on activator used.
• Keep spray gun nozzle 6 – 10 inches from the vehicle to avoid entrapment of air in paint film.
• Always keep containers tightly closed to prevent moisture contamination.
• Clean equipment thoroughly after use.

Dry Times

NOTES

• Do not flash for more than 1 hour between coats. If more than 1 hour @ 70°F (21°C) is reached, wait at least 5 hours and scuff with a red or gray scuff pad before applying more clear or basecoat. Lightly scuff surface and degrease before application.
• A minimum of 2.2 mils dry‐film‐thickness is required for optimum UV resistance.

SURFACE PREPARATION

• Apply basecoat color per manufacturer’s recommended procedures.
• Allow 15 minutes dry time before applying clearcoat.
• In temperatures below 70°F, a longer dry time is necessary for each coat of basecoat.
• Thoroughly tack surfaces to be painted with a clean tack cloth before applying clearcoat.

RECOAT INSTRUCTIONS If recoating after 24 hours, then sand with 1000 grit sandpaper before recoating. On sand‐thru areas, apply heat before recoating to eliminate featheredge lifting.

Technical Data

SDS